Table of Contents
Advertisement
6.
Put the low-voltage cable in the ground with
stakes or bury the cable. Refer to
wire into position with stakes on page 21 or
To bury the boundary wire or the guide wire
on page 21 .
7.
Connect the wires to the charging station.
To install the boundary wire on
Refer to
page 20 and To install the guide wire on
page 20 .
8.
Attach the charging station to the ground
with the supplied screws.
CAUTION: Do not make new
holes in the charging station plate.
CAUTION: Do not put your feet on
the charging station.
3.4.2 To install the boundary wire
1.
Put the boundary wire around all of the work
area. Start and complete the installation
behind the charging station.
CAUTION: Do not put unwanted
wire in a coil. The coil causes
interference with the product.
2.
Open the connector and put the boundary
wire in the connector.
3.
Close the connector with a pair of pliers.
4.
Cut the boundary wire 1-2 cm / 0.4-0.8 in.
above each connector.
5.
Push the right connector onto the metal pin
on the charging station with the mark "R".
6.
Push the left connector onto the metal pin
on the charging station with the mark "L".
3.4.3 To install the guide wire
1.
Open the connector and put the wire in the
connector.
2.
Close the connector with a pair of pliers.
20 - Installation
3.
Cut the guide wire 1-2 cm / 0.4-0.8 in. above
To put the
each connector.
4.
Push the guide wire through the slot in the
charging station plate.
5.
Push the connector onto the metal pin on
the charging station with the mark "G".
6.
Put the end of the guide wire at the eyelet
on the boundary wire.
7.
Cut the boundary wire with a pair of wire
cutters.
8.
Connect the guide wire to the boundary wire
with a coupler.
a)
Put the 2 ends of the boundary wire
and the end of the guide wire into the
coupler.
Note: Make sure that you can see the
end of the guide wire through the
transparent area of the coupler.
b)
Push the button on the coupler with an
adjustable pliers.
9.
Attach the guide wire to the ground with
stakes or bury the guide wire in the ground.
Refer to
stakes on page 21 or To bury the boundary
wire or the guide wire on page 21 .
CAUTION: Twinned cables,
or a screw terminal block that
is insulated with insulation
tape are not satisfactory
splices. Soil moisture will
cause the wire to oxidize and
after a time result in a broken
circuit.
To put the wire into position with
1054 - 001 -
Advertisement
Table of Contents
