McCulloch 967059700 Operator's Manual page 17

Table of Contents

Advertisement

Put the boundary wire 20 cm / 8 in. (C) from
an obstacle that is 1-5 cm / 0.4-2 in. high.
Put the boundary wire 5 cm / 2 in. (D) from
an obstacle that is less than 1 cm / 0.4 in.
If you have a paving stone path that is in
level with the lawn, put the boundary wire
below the paving stone.
Note: If the paving stone is minimum 30 cm /
12 in. wide, use the factory setting for the
Drive Past Wire function (ROB R800, ROB
R1000) to cut all the grass adjacent to the
paving stone.
CAUTION: Do not let the product
operate on gravel.
If you make an island, put the boundary wire
that runs to and from the island near
together (E). Put the wires in the same
stake.
Make an eyelet (F) where the guide wire is
to be connected to the boundary wire.
CAUTION: Do not make sharp
bends when you install the
boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
3.3.3.1 To put the boundary wire in a slope
The product can operate in 25% slopes. Slopes
that are too steep must be isolated with the
boundary wire. The gradient (%) is calculated as
height per m. Example: 10 cm / 100 cm = 10%.
1054 - 001 -
25 cm / 10"
> 5 cm/>2"
Slopes steeper than 15% at the outer edge
of the work area must be isolated with
boundary wire. Put the boundary wire
approximately 20 cm / 8 in. (A) on level
ground before the slope.
Slopes adjacent to a public road must be
isolated with boundary wire. Put a fence or a
protective wall along the outer edge of the
slope.
3.3.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 work areas. The
passage must be a minimum of 60 cm / 24 in.
wide.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
3.3.3.3 To make an island
Put the boundary wire to and around the
obstacle to make an island.
Put the 2 sections of boundary wire that run
to and from the obstacle together.
Put the 2 sections of boundary wire in the
same stake.
10%
100 cm / 40"
>15%
A
10 cm / 3.9"
Installation - 17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rob r800Rob r1000Rob r600967059800

Table of Contents