Table of Contents
Advertisement
Test settings > Test OUT > Remote start 1
or Remote start 2 .
OK .
4.
Push
5.
Push the START button.
6.
Close the hatch.
7.
Make sure the product can find the area.
3.9.3.5 To set the Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 25 cm. You can select a
distance of 20-30 cm.
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure
Drive Past Wire .
3.
Use the number buttons to set the distance
in cm.
4.
Push the BACK button.
3.9.4 Security level
There are 3 security levels for the product.
Function
Low
Alarm
PIN request
Time lock
X
•
Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
•
PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for
some time. The lock is extended for each
new incorrect try.
•
Time lock - The product is locked if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
24 - Installation
3.9.4.1 To change the PIN code
1.
2.
3.
4.
5.
6.
7.
3.9.4.2 To set the security level
Select 1 of 3 security levels for your product.
1.
Installation >
2.
3.
4.
3.9.4.3 To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
Medium
High
adjacent installations have a very similar signal.
X
1.
X
X
2.
X
X
3.
4.
3.9.5 Settings
In settings you can change the general settings
to your product.
Do steps 1–3 in
To get access to the menu
on page 22 .
Use the multi-choice buttons to move
through the menu structure
Change PIN code .
Enter the new PIN code.
OK .
Push
Enter the new PIN code.
OK .
Push
Make a note of the new PIN code. Refer to
Introduction on page 3 .
To get access to the menu
Do steps 1–3 in
on page 22 .
Use the multi-choice buttons to move
through the menu structure
Security level .
Use the multi-choice buttons to select the
level of security.
OK .
Push
Place the product in the charging station.
To get access to the menu
Do steps 1–3 in
on page 22 .
Use the multi-choice buttons to move
through the menu structure
loop signal .
OK and await confirmation that the
Push
loop signal has been generated. This
normally takes about 10 seconds.
Security >
Security >
Security > New
1054 - 001 -
Advertisement
Table of Contents
