Table of Contents
Advertisement
The test has failed if the product cannot follow
the guide wire all the way to the connection point
with the boundary wire. It is likely that the
installation has not been carried out in
accordance with the instructions in
guide wire on page 20 .
Note: Common errors are for instance that there
is not enough open space to the left of the guide
wire as seen facing the charging station, or that
the guide wire is not laid at an angle on a steep
To examine where to put the
slope. Refer to
guide wire on page 18 .
If the test fails, rectify the installation and run a
Calibrate guide .
new test with
3.9.5.7 To reset all user settings
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure
user settings .
3.
Use the multi-choice buttons to select
country and then push
4.
Enter the PIN code.
5.
Push
OK to reset all the user settings.
Security level, PIN code, Loop signal,
Note:
Messages, Date & Time, Language and Country
settings are not reset.
3.9.5.8 The About menu
About menu displays information about the
The
product, for example serial number and firmware
versions.
26 - Installation
To install the
Settings > Reset
OK .
1054 - 001 -
Advertisement
Table of Contents
