Removing The Ni 653X Cable Adapter From Its Enclosure - National Instruments NI 6535 User Manual

Removing the NI 653x Cable Adapter from its Enclosure

Be sure to remove the screws from side with the NI logo label, as shown in Figure 3.
Note
© National Instruments Corporation
You will need to remove the NI 653x cable adapter from its enclosure to
connect signals. To remove the cable adapter from its enclosure, complete
the following steps:
1. Remove the screws from the cable adapter enclosure top cover,
as shown in Figure 3.
1 M2.5 x 6 mm Philips Flathead Countersunk Screws
Figure 3. Remove Screws from the Enclosure
2. Remove the enclosure top cover.
5
1
NI 653x Cable Adapter User Guide