Table of Contents
Advertisement
Option #
Option Description
Cont.
23
Remote Start Engine Run Time
24
Smart Tachless Voltage Adjust
80-100%
(Only when option #1 is set to
Tachless)
25
Option reset to default (*) values
PROGRAMMABLE OPTION DESCRIPTIONS:
1. ENGINE MONITORING:
This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a
Tach signal (RPM) or for "Ultra-Smart" Tachless mode that monitors voltage level. See pages 14-15 for more
information and additional steps for actual Tach learning and Tach finder modes.
2. AUTOLOCK/UNLOCK W/IGNITION:
Controls whether the doors will automatically lock when the ignition is turned on and will unlock when the ignition is
turned off. Doors will not lock if they are open to prevent locking the keys in.
3. PASSIVE ARMING:
With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and the last door has been
closed. Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the
system will wait and begin countdown again when closed.
4. ACTIVE RE-ARM:
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not
been opened. This is handy if the vehicle is accidentally disarmed without your knowledge.
5. PASSIVE LOCKS:
This option controls whether the doors will lock when Passive Arming occurs. Note: This may increase the risk of
locking keys in the vehicle.
PROGRAMMABLE OPTIONS Cont.
Option values
Button #1 = 12 Min.
Button #2 = 24 Min.
Button #3 = 36 Min.
Button #4 = 48 Min.
Button #1 = Decrease by 1%
Button #2 = Increase by 1%
Button #3 = Set to 90% default
Button #2 Only
19
Lock Button #1
Unlock Button #2
12 Min.
*24 Min.
-1%
Reset options
+1%
Advertisement
Table of Contents
