Changing Product Names - Prince Castle EHB22 Series Operation Manual

Extended Holding Bin
General Market Series
The EDIT PRODUCT NAME menu is used to change a default product name to one of your own choosing.
1
Press and hold the PRINCE CASTLE LOGO button on the button bar,
then immediately press and hold the ENTER button until the display shows one of six programming menus.
Use the UP or DOWN Arrow button to scroll to the PROD NAME ↑ ↓ ENTR (Edit Product Name) menu.
NOTE: The default menu items and names are listed on page 13.
Press and release the ENTER button to enter the Edit Product Name menu.
2
Use the UP or DOWN Arrow button to scroll through the list of products.
When the desired product is displayed, press the ENTER button to select it.
The first letter (in this case, the E ) will start blinking.
To change the blinking E, use the UP or DOWN Arrow button to scroll to the desired letter/number/symbol.
3
When the desired selection is displayed, press the PAN Arrow button to move to the next digit. Repeat for all digits.
NOTE: Holding the UP or DOWN Arrow button for longer than 2 seconds will cause the display to automatically scroll.
4 When all four digits have been changed, press the ENTER button to select the new name.
The display will show PROD NAME ↑↓ ENTR. Repeat Steps 2 – 4 for any other product.
5
Press and release the PRINCE CASTLE LOGO button at any time to exit the Program Mode and return to the Run Mode.
NOTE: If the ENTER button has not been pressed to save any changes, the program will revert to the original names.
Printed in USA 07/2023 © 2023

Changing Product Names

...
10 540-1730_EN rev.B