Installing Winmodem Drivers With Windows Nt; Without Pnp Enabled - 3Com U.S. Robotics 56K Winmodem Manual

I I I I W W W W
NSTALLING THE NSTALLING THE NSTALLING THE NSTALLING THE
You are ready to install communications
software. Refer to the manual of the
communications software for instructions
on installation.
After you install your communications
software, you are ready to use the
Winmodem.
® ® ® ®
W W W W 95, 95, 95, W W W W 95,
INMODEM WITH INMODEM WITH INMODEM WITH INMODEM WITH INDOWS INDOWS INDOWS INDOWS
Installing Winmodem Drivers
with Windows NT 4.0

without PNP Enabled

1.
After installing the modem, turn on your
2.
Insert the installation disk into the disk
3.
Click Start and select Run.
4.
Type A:\Setup and click OK.
5.
When the Setup program starts, click
6.
The resource page contains the
98, 98, 98, 98, W W W W NT 4.0 NT 4.0 NT 4.0 NT 4.0
INDOWS INDOWS INDOWS INDOWS AND AND AND AND INDOWS INDOWS INDOWS INDOWS
Windows NT workstation.
drive.
Install.
configuration information of your
Winmodem in Windows NT. COM port,
I/O address, and Interrupt Request Line
are the three resources that may require
adjustment.
19