Tv Output Signal - Toshiba Equium A110-233 User Manual

Problem
Double-clicking does
not work
The mouse pointer
moves too fast or too
slow
The mouse pointer
moves erratically
USB
Refer also to your USB device's documentation.
Problem
USB device does not
work

TV output signal

Problem
Display on TV is poor
No display
If you turn the computer off in Standby Mode while the display is on a TV,
the computer will select either the internal LCD or an external computer
CRT as the display device the next time it is switched on.
User's Manual
Procedure
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.
Try changing the speed setting in the mouse
control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Pointer Options tab.
3. Set the speed as instructed and click OK.
The mouse might be dirty. Refer to your mouse
documentation for instructions on cleaning.
If problems persist, contact your dealer.
Procedure
Check for a firm cable connection between the
USB ports on the computer and the USB device.
Make sure the USB device drivers are properly
installed. Refer to your Windows documentation
for information on checking the drivers.
If problems persist, contact your dealer.
Procedure
Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
If problems persist, contact your dealer.
Troubleshooting
The Keyboard.
9-10