Combustion Head Setting; Air Damper Adjustment - Riello 40 G7 140 Installation, Use And Maintenance Instructions

Light oil and kerosene burner
Table of Contents

Advertisement

Available languages

Available languages

2
PRESSURE:
12 bar: pressure suitable for light oil in most cases.
14 bar: improves flame retention; it is therefore suitable for ignitions at low temperatures.
FOR KEROSENE DECREASE PRESSURE
8 bar:
pressure suitable for kerosene in most cases.
10 bar: maximum pressure for kerosene.
3

COMBUSTION HEAD SETTING

This is done when fitting the nozzle, with the blast tube removed.
It depends on the output of the burner and is carried out by rotating the regulating rod, till the terminal
plane of the blast tube is level with the set-point, as indicated in the schedule.
Terminal plane of the blast tube
D5244
Blast tube
4

AIR DAMPER ADJUSTMENT

The regulation of the air-rate is made by adjusting the air
damper (1), after loosing the screws (2).
The settings indicated in the schedule refer to the burner
with its metal cover fitted and the combustion chamber
with "zero" depression.
These regulations are purely indicative. Each installation
however, has its own unpredictable working conditions: actu-
al nozzle output; positive or negative pressure in the
combustion-chamber, the need of excess air, etc. All these
conditions may require a different air-damper setting.
It is important to take account of the fact that the air
output of the fan differs according to whether the
burner has its metal cover fitted or not.
Therefore we recommended to proceed as follows:
– adjust the air damper as indicated in the schedule (4);
– mount the cover, simply by means of the upper screw;
– check smoke number;
– should it become necessary to modify the air output, remove the cover by loosening the screw,
adjust the air damper, remount the cover and finally recheck the smoke number.
2374
2
5
3
1
Regulating rod
Shutter
In the sketch on the left, the combustion
head is set for an output of 1.00 GPH at
12 bar (for gas-oil) or 1.25 GPH at 8 bar
(for kerosene).
The shutter is level with set-point 3, as
required by the schedule at page 5
2
6
GB
1
2
D5514

Advertisement

Table of Contents
loading

This manual is also suitable for:

40 g71603745959

Table of Contents