Using The Cli; Configuring The Poe Parameters Manually - TP-Link T1500-28PCT User Manual

Managing System
6.2

Using the CLI

6.2.1 Configuring the PoE Parameters Manually

Follow these steps to configure the basic PoE parameters:
Step 1 configure
Enter global configuration mode.
Step 2 power inline consumption power-limit
Specify the maximum power the PoE switch can supply globally.
power-limit
384.0W, and the default value is 384.0W.
Step 3 interface { fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter Interface Configuration mode.
port
port-list:
Step 4 power inline supply { enable | disable }
Specify the PoE status for the corresponding port.
enable |
Step 5 power inline priority { low | middle | high }
Specify the PoE priority for the corresponding port.
low | middle |
exceeds the system power limit, the switch will power off PDs on low-priority ports to ensure
stable running of other PDs. The default setting is low.
Step 6 power inline consumption { power-limit | auto | class1 | class2 | class3 | class4 }
Specify the maximum power the corresponding port can supply.
power-limit | auto | class1 | class2 | class3 |
corresponding port can supply. The following options are provided: Auto represents that
the switch will allocate the maximum power that the port can supply automatically. Class1
represents 4W, Class2 represents 7W, Class3 represents 15.4W and Class4 represents 30W,
or you can enter a value manually. The value ranges from 1 to 300. It is in the unit of 0.1 watt.
For instance, if you want to configure the maximum power as 5W, you should enter 50. By
default, it is Class4.
Step 7 time-range name
Specify a time range for the port. Then the port will supply power only during the time range.
For how to create a time range, refer to
name:
Step 8 show power inline
Verify the global PoE information of the system.
: Specify the maximum power the PoE switch can supply. It ranges from 1.0 to
: Specify the Ethernet port number, for example 1/0/1.
Specify the list of Ethernet ports, for example 1/0/1-3, 1/0/5.
disable: Enable or disable the PoE function. By default, it is enable.
high: Select the priority level for the corresponding port. When the supply power
Specify the name of the time range.
class4: Select or enter the maximum power the
Time Range Configuration.
PoE Configurations
Configuration Guide 70