Scan Settings - CipherLab 9700A User Manual

BEEPER
Setting
Low Battery LED
Beep when good read
Low Battery Beep
Temperature Warning

3.13.2. SCAN SETTINGS

SCAN SETTINGS
Setting
Power Level
Trigger Key
Check to enable the LED indicator of RK25 UHF RFID Reader which
will flash in red 5 times every 2 minutes or when it wakes up from
suspend mode if the battery power level is 0%
Select to mute the beeper for good read, or set the sound for good
read.
To enable the low battery notification sound which occurs when the
RK25 UHF RFID Reader's battery power level is 0%.
Check to enable the notification to prompt you if the RK25 UHF RFID
Reader is over 65℃. The high temperature warning will not go off
until the temperature drops down to 62℃.
To drag the slider to adjust the power level for reading distance.
Set the reading mode when pressing the trigger once:
Once

To read the tag(s) once.
Continuous

To keep reading the tag(s) till the trigger is released.
Alternate

To perform "Once" and "Continues" one after the other
repeatedly.
161
Customize Project Configuration
Description
Description