3M Matic 7000a Instructions And Parts List page 26

Specifications (continued)
(To relocate upper frame or outer columns, see "Special Set-Up Procedure".)
A
C
Note: Length of boxes in illustrations above are not to scale.
Case Height Range Illustration:
A. Standard Machine Position:
B. TBA set Machine Position:
C. Alternate Machine Position:
D. Raised Machine Position:
* Boxes narrower than 8" [200mm] may require more frequent belt replacement because of limited contact area.
** Alternate Position "C" / LHB Alternate Position requires lower machine production speed.
Special modifications may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note: The case sealer can accommodate most boxes within the size range listed above. However, if the
box length (in direction of seal) to box height ratio is .6 or less, then several boxes should be test run to assure
proper machine performance. Any box ratio approaching this limitation should be test run to assure performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL
7000a-7000a3 Pro - NA
Minimum/Maximum Box Height Combinations
Minimum / Maximum
111mm 711mm
[4 3/8"] [28"]
Operating
Range
Box
Box
Standard Machine Position:
Outer Column against Stop /
Upper Assembly - Lowest
Position on Inner Column
Minimum / Maximum
38mm 641mm
[1 1/2"] [25 1/4"]
Operating
Range Box
Box
Alternate Position:
Column's Lowered
2 3/4" [70mm]
Outer Columns positioned against Stop with Upper Drive Assembly set to
Lowest Position on Inner Columns. Tape Leg Length - 2 3/4" [70mm].
Lowest Box Height for Short Tape Leg Length (i.e. Outer Columns lowered
1/2" [13mm] - See Special Set-Up Procedure). Tape Leg Length - 2" [50mm]**.
Lowest possible Box Height for LHB - Alternate Position.(i.e. Outer columns lowered
2 3/4" [70mm] from Standard Position [A]). LHB Tape Leg Length - 1 3/8" [35mm].
Maximum Box Height (i.e. Outer Columns and Upper Drive Assembly in Highest
Position - See Special Set-Up Procedure).Tape Leg Length - 2 3/4" [70mm].
BOX HEIGHT
B
D
SHOULD BE GREATER THAN .6
=
14
TBA
Operating
Range
Box
Box
Alternate Position:
Minimum / Maximum
311mm 914mm
[12 1/4"] [36"]
Operating
Range Box
Box
Outer Column:
Fully Raised Position
2014 June