Advertisement
2/6 IMAGE
The IMAGE page allows for control
of image processing and video
settings. These image settings are
adjustments applied to Cine Raw
files as metadata.
MA STER GAMMA
Sets the relationship between the
signal level and brightness output of the image.
MA STER GAIN
Adjusts the overall signal level of the image linearly.
MA STER BL ACK
Adjusts the baseline black level. The default of 0 should produce images with black at 0
on a waveform monitor.
PA & PAO
The camera adds a Production Area (PA) with the specified frame size as an overlay on
the image. PAO is the Production Area Offset, which will move the Production Area from
the center of the image both vertically and horizontally. 0, 0 is the default.
ZOOM
Changes the zoom level of the video output.
COLOR BARS
Switches all video outputs to display SMPTE HD color bars.
VIDEO SYSTEM
Sets the video output to one of the valid video systems. The video outputs will change
immediately. However, the new video system must be confirmed to take effect.
Vision Research, Inc. | Phantom T-Series Camer a Manual
3/6 SETTINGS
The SETTINGS page allows
for user setups to be saved
and recalled.
0 – 5
There are six available entries.
By selecting one of the slots,
users can save or recall that
particular setup to quickly change all
parameters of the camera at a later date. The values in parentheses are meant as a quick
reminder of camera settings.
Please note that all camera settings, including video mode, sync mode, image and advanced
settings are included. These settings are saved after the camera powers down.
FACTORY DEFAULTS
Recalls the factory defaults to bring the camera back to the original settings from the last time
it left the Vision Research factory. This includes all capture, calibration, image processing and
video parameters.
This is an important troubleshooting step.
4/6 INFO
The INFO page displays unique
information about the camera, including:
Model: name, memory and serial
number.
Firmware level
Current Temperature of the Sensor
and Camera, and the power of the Fan.
Factory-assigned IP address of the camera.
User-defined IP address (secondary IP) which can be set to 'AUTO' for DHCP compatibility
or used with a defined IP range outside of the Phantom 100.100 network. This is set using
Phantom PCC software.
10-Gigabit (10Gb) IP address of the camera as assigned by Vision Research. If this is blank,
the 10Gb Ethernet option has not been enabled on this camera.
Chapter 4: On-Camera Control s | 19
Advertisement
