Advertisement
3/6 SETTINGS
The SETTINGS page allows
for user setups to be saved
and recalled.
0 – 5
There are six available entries.
By selecting one of the slots,
users can save or recall that
particular setup to quickly change all
parameters of the camera at a later date. The values in parentheses are meant as a quick
reminder of camera settings.
Please note that all camera settings, including video mode, sync mode, image and advanced
settings are included. These settings are saved after the camera powers down.
FACTORY DEFAULTS
Recalls the factory defaults to bring the camera back to the original settings from the last time
it left the Vision Research factory. This includes all capture, calibration, image processing and
video parameters.
This is an important troubleshooting step.
4/6 INFO
The INFO page displays unique
information about the camera, including:
Model: name, memory and serial
number.
Firmware level
Current Temperature of the Sensor
and Camera, and the power of the Fan.
Factory-assigned IP address of the camera.
User-defined IP address (secondary IP) which can be set to 'AUTO' for DHCP compatibility
or used with a defined IP range outside of the Phantom 100.100 network. This is set using
Phantom PCC software.
10-Gigabit (10Gb) IP address of the camera as assigned by Vision Research. If this is blank,
the 10Gb Ethernet option has not been enabled on this camera.
Chapter 4: On-Camera Control s | 19
Advertisement
