Table of Contents
Advertisement
11
Configuring the power supply
With the fourth generation of the QUINT POWER power
supply, it is now possible for the first time to adapt the
behavior of the power supply. In addition to setting the
output voltage and selecting the output characteristic
curves, you can configure signal outputs Out 1, Out 2, and
floating signal contact 13/14, for example. Configuration of
the remote input for controlling the power supply or
specification of signal options and signal thresholds also
extend the range of possible applications.
The power supply is configured via the device's internal NFC
(near field communication) interface. This is located behind
the QR code on the front.
The power supply behaves like a passive NFC tag.
An auxiliary power source is required in order to
supply the power supply with configuration data.
11.1
Configuration with PC software
In order to configure the power supply via the NFC interface,
the following hardware and software requirements must be
met:
–
PC or notebook (as of Windows 7, Microsoft.Net
Framework 4.5, USB 2.0 interface, 50 MB hard disk
capacity, QUINT POWER software).
–
Programming adapter:
TWN4 MIFARE NFC USB ADAPTER (Order No.
2909681) is plugged into the USB interface.
–
Programming software: the QUINT POWER software
has been successfully installed.
109369_en_00
11.2
Configuring the power supply
To configure the power supply, proceed as follows:
–
Before you can configure the power supply, it should
either be disconnected from the supply voltage or
switched to SLEEP MODE.
–
To switch the power supply to SLEEP MODE, use one
of the external circuits. The following connection
versions are possible between the Rem (remote input)
and SGnd (signal ground) connection terminal blocks.
Figure 20
SLEEP MODE connection versions
–
Hold the USB-PROG-ADAPTER in front of the mounted
power supply such that the NFC antenna symbol is over
the QR code.
Figure 21
Configuration of the power supply
–
In the programming interface of the QUINT POWER
software, press the [Read] button. The current device
and configuration data for the power supply is read and
displayed.
If a connection cannot be established between the
USB-PROG-ADAPTER and the power supply,
more detailed information can be found in the user
manual for the QUINT POWER software.
For information regarding the configuration of the
power supply, such as selecting the characteristic
curve and output parameters, refer to the user
manual for the QUINT POWER software.
QUINT4-PS/12DC/24DC/5/PT
PHOENIX CONTACT
29/49
Advertisement
Table of Contents
