Table of Contents
Advertisement
8
Mounting/removing the power
supply
8.1
Mounting the power supply unit
Proceed as follows to mount the power supply:
1.
In the normal mounting position the power supply is
mounted on the DIN rail from above. Make sure that the
universal DIN rail adapter is in the correct position
behind the DIN rail (A).
2.
Then press the power supply down until the universal
DIN rail adapter audibly latches into place (B).
3.
Check that the power supply is securely attached to the
DIN rail.
Figure 7
Snapping the power supply onto the DIN rail
A
Click
B
8.2
Removing the power supply unit
Proceed as follows to remove the power supply:
1.
Take a suitable screwdriver and insert this into the lock
hole on the universal DIN rail adapter (A).
2.
Release the lock by lifting the screwdriver (B).
3.
Carefully swivel the power supply forward (C) so that
the lock slides back into the starting position.
4.
Then separate the power supply from the DIN rail (D).
Figure 8
Removing the power supply from the DIN rail
B
A
109369_en_00
D
C
8.3
Retrofitting the universal DIN rail adapter
For installation in horizontal terminal boxes it is possible to
mount the power supply at a 90° angle to the DIN rail.
No additional mounting material is required.
Use the Torx screws provided to attach the
universal DIN rail adapter to the side of the power
supply.
8.3.1
Disassembling the universal DIN rail adapter
Proceed as follows to disassemble the universal DIN rail
adapter that comes pre-mounted:
1.
Remove the screws for the universal DIN rail adapter
using a suitable screwdriver (Torx 10).
2.
Separate the universal DIN rail adapter from the rear of
the power supply.
Figure 9
Disassembling the universal DIN rail adapter
QUINT4-PS/12DC/24DC/5/PT
PHOENIX CONTACT
21/49
Advertisement
Table of Contents
