Troubleshooting - Power smart HB2805A Instruction Manual

For additional replacement shear pins, please call the customer service department at (800)791 9458.
1. Turn off the machine and wait for all moving parts to come to a complete stop. Remove any
remnants of the broken shear pin. It may be necessary to unscrew the nut from the broken shear pin
and drive out the broken pin.
2. Insert a new shear pin through the hole in the auger shaft and tighten using the shear pin nylon lock
nut. Do not over-tighten the nylon lock nut.
NOTICE: Never replace the shear pins with standard pins or fasteners. Damage may occur to the
snow blower and drive systems.

TROUBLESHOOTING

Problem
The snow thrower does
not start.
The motor is on, but
the impeller does not
turn.
NOTE: Please contact the customer service for any questions.
Cause
The battery is not charged.
The switch is defective
Battery is too cold.
The battery is not attached to
the motor.
Battery may require service or
replacement.
The belt is damaged.
Solution
Charge the battery by following the
procedures in the battery and charger
manual.
Have the switch replaced by an
authorized service center.
Remove battery from snow thrower.
Place battery on charger and allow to
charge for 10 minutes. Remove from
charger and install in Snow thrower for
use.
Check the connection between the motor
connector and the battery.
Call toll free helpline, at 1-800-791-9458
or replace battery.
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
15