Connecting To The Water Supply - Atag VA5511AT User Information

Connecting to the water supply

Inlet
• Water pressure: 1–10 bar (flow pressure)
• The appliance can be connected to cold and hot water, maximum
temperature 65 °C.
• The site must provide a regulating tap with G 3/4" outlet.
• The appliance must be connected with the plastic pressure hose sup-
plied (with filter, in accordance with EN61770, 10 bar.)
• Installation of an IRG filter is recommended as part of the house's
water system.
• After the regulating tap is opened, no water may leak out of the con-
nection fittings.
• If connecting to the hot water system, the threaded joints must be
checked a few minutes after the machine is first used and tightened
if necessary. (Be careful not to overwind the threaded joints.)
Drainage
• The flexible drain hose with an inner diameter of 22 mm is to be laid
with no kinks.
• The appliance can also be installed above the level of the sink spigot.
A return inhibitor is integrated into the machine's drainage and
therefore connection fittings with non-return valves are not neces-
sary.
• The preferred connection is via the spigot of the sink outlet in the
unit next to the machine.
• The highest point of the drain hose is not to be more than 500 mm
above the floor of the appliance.
38