What To Do If; Remedying Small Malfunctions - Atag VA5511AT User Information

What to do if...

Remedying small malfunctions

If the acoustic signal is activated, warning tones sound if there are
faults.
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact the Customer Care De-
partment and inform them of the fault code.
Malfunction
1 short warning tone
continuously repeated can
be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing:
fault code
played in the multi-dis-
play:
(Problems with water in-
let)
30
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Å 10
is dis-
Filters in the base of the
dishwasher compartment
are blocked.
Water inlet hose
has not been correctly posi-
tioned.
Possible cause Remedy
Check the water tap and
have it repaired if necessary.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Check the position of the
hose.