Table of Contents
Advertisement
With delay start you can choose when
you want the programme to end. The
start of a programme can be delayed
from 30 minutes up to a maximum of 24
hours, allowing you to make use of
night-time economy electricity rates, for
example.
The current time of day needs to
have been set for delay start to work
correctly.
To select delay start
^ Select the programme you want and
then press the m button.
9:51
Start at:
Finish at:
The display shows the current time of
day and the time the programme is due
to end.
^ Use the + button to select the time
you want the programme to end at.
9:51
Start at:
Finish at:
The first press on the button will adjust
the programme end time to the next full
or half hour. Each subsequent press on
the button will delay the programme
end time by 30 minutes.
Use the – button to shorten the time if
you have chosen too long a time.
^ Confirm the programme end time by
pressing the OK button.
9:51
11:19
13:32
15:00
To begin delay start
^ Press the Start/Stop button.
60°C
Start in:
The display will show how long in h:min
you have to wait until the programme
starts.
To alter delay start
^ Press the m button.
^ Use the + and – buttons to alter the
time you want the programme to end
at.
^ Press the OK button to confirm.
To cancel delay start
^ Press the Start/Stop button.
The actual load size can only be
determined accurately by the
machine once the programme has
started. The programme end time
may, therefore, turn out to be a bit
later or earlier than first indicated.
N.B.: If, under the settings menu, you
have chosen not to have the time
displayed the display will show how
long in h:min there is left until the
programme starts / stops instead of
the actual time that it will start / stop
at.
Delay start
1600 rpm
3:41
h
21
Advertisement
Table of Contents
