To Wire And Mount The Dat Sensor - Carrier SPS Installation Manual

Duct Air Temperature sensor

To wire and mount the DAT sensor

Drill or punch a .25 inch (.6 cm) hole in the top or side of the supply duct.
1
Insert the sensor's probe into the hole. The probe can touch side of duct.
2
Snap the grommet into the hole until it is secure.
3
Pull on the sensor's wiring until the sensor is snug against the grommet.
4
Wire the sensor to the Open controller. See the controller's Installation and Startup Guide for details.
5
22 Carrier Sensors