To Change A T59 Sensor's Options - Carrier SPS Installation Manual

Alternate space temperature sensor
SEN
T-55 sensor

To change a T59 sensor's options

You can change user options and field service options in the T59's display. The options are displayed on
pages referenced by page number. See tables below.
NOTE Because the T-59 is not a communicating device, the T-59's setpoint and offset values must be set to
match the same values in the associated controller.
To display an
option page
To edit a value
To return sensor to
normal operation
14
Blk (Gnd)
Sensor
wiring
Red
In the User Options and Field Service Options tables below, find the option you
3
want to change and its page number.
With the sensor displaying the current temperature, simultaneously press and
4
hold the
page 100.
Release the keys.
5
Press
6
NOTE To display a field service option page (126 to 132), press the
until you see 1- -, then simultaneously press and hold
approximately 2 seconds, the display shows 126. Press
page you want.
NOTE If you do not press a key for 30 seconds, the sensor automatically returns to
normal operation.
When the option page you want is displayed, press
7
Press
8
number that represents the value you want. See tables below.
Press
9
NOTE If you do not press a key for 10 seconds, the sensor automatically returns to
option page.
From an option page, press
SEN SET
White
Sensor
wiring
Red
Jumper
terminals
Blk (Gnd)
T-56 sensor
and keys. After 30 seconds, the sensor's display shows option
repeatedly until the display shows the page number you want.
repeatedly to cycle through the numbers 00 to 12. Stop at the
to save the selected value and return to option page.
until the display shows 1- -. Then press
Brn
Sensor
Blk
wiring
Blu
OPB COM PWR
- +
T-59 sensor
key
and . After
until you see the
to enter edit mode.
.
Carrier Sensors