Advertisement
Available languages
Available languages
8
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
LEDs of the battery show
nothing
Nut cannot be screwed on to
the cut threaded rod.
Product does not start even
though the control switch is
pressed.
Cutting blade cannot be in-
stalled (securing screw can-
not be screwed in).
*2362890*
Possible cause
Battery faulty.
Burr formation at cut edge.
Function selector switch is in the
position and the cutting arm is
fully open.
Cutting blades installed wrong way
round.
2362890
Action to be taken
▶ Contact Hilti Service.
▶ Check the cut face for burrs;
deburr the cut if necessary.
→ page 11
▶ Set the function selector switch
to
.
▶ Check the orientation of the
cutting blades:
▶ Movable cutting arm → narrow
side of the cutting blade up.
▶ Stationary cutting arm →
broad side of the cutting blade
up.
English
13
Advertisement
