Advertisement
Available languages
Available languages
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.5
Using scaffold hook
The product has a scaffold hook that you can use to hook the product briefly to a railing, for example. In
order to use the scaffold hook, flip the scaffold hook out.
Important instructions for handling the scaffold hook:
•
Do not use the scaffold hook to lift the product or to attach a retaining strap.
•
Make sure that the product is not unsteadied by strong wind and can be made to fall off the railing by
vibration, for example.
•
Hook the product with the scaffold hook only to railings or other firm structures. Do not hook the product
on to a tool-belt or other items of clothing.
•
Do not apply excessive force to the scaffold hook when hooking up. The scaffold hook could bend and
the product could fall.
•
Before every use, check the scaffold hook and the attachment points of the scaffold hook to the housing
for visible damage, for example distortions and breakages. Use the scaffold hook only when it is in
perfect working order.
5.6
Removing/installing accessories
You can install different accessories on the threaded-rod cutter, for example a parallel guide or a waste
container for offcuts.
1. Press and hold down the release button (mounting adapter).
2. Pull the accessory to the side and out of the mounting adapter.
3. To install an accessory, push the accessory into the mounting adapter until it engages with an audible
click.
5.7
Adapting parallel guide for M6 threaded rods
If you are cutting M6 threaded rods and using the parallel guide, you have to adapt the parallel guide
accordingly with an adapter.
1. Press and hold down the release button (mounting adapter).
2. Pull the accessory to the side and out of the mounting adapter (1).
3. Pull the M6 adapter out of the insert of the parallel guide (2).
4. Mount the M6 adapter on the parallel guide (3).
▶ The M6 adapter engages.
5. Push the parallel guide into the mounting adapter until it engages with an audible click.
5.8
Changing the cutting blades
You can use a set of cutting blades 2× by swapping over the cutting blade on the moving cutting arm
with the cutting blade on the stationary cutting arm.
Removing cutting edges
1. Set the function selector switch to the
2. Move the cutting arm until the securing screw is readily accessible.
3. Set the function selector switch to the
4. Remove the depth gauge by pressing and holding down the release button and pulling out the depth
gauge.
5. Use the hex key to slacken the securing screw in the movable cutting arm.
6. Remove the cutting edge from the movable cutting arm.
7. Use the hex key to slacken the securing screw in the stationary cutting arm.
8. Remove the cutting edge from the stationary cutting arm.
Installing cutting blades
9. Remove the cutting edges. → page 10
10
English
2
3
4
function.
function and remove the battery.
5
2362890
*2362890*
Advertisement
