Hilti NURON STR 4-22 Original Operating Instructions page 12

3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless (battery-powered) threaded-rod cutter. It is designed for cutting threaded
rods of sizes:
• W3/8 (mild steel, galvanized, or stainless steel)
• M6 and M8 (mild steel, galvanized, or stainless steel)
• M10 (only mild steel, galvanized)
The product is not suitable for cutting stainless steel M10 threaded rods.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
Cordless threaded-rod cutter, waste container, depth gauge, parallel guide, set of cutting edges, hex key,
operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
6 English
1
Cutting arm (movable)
@
Cutting arm (stationary)
;
Release button (depth gauge)
=
Depth gauge
%
Function selector switch
&
Control switch
(
Grip
)
Release button, battery
+
Battery status indicator
§
Scaffold hook
/
Release button (mounting adapter)
:
Mounting adapter for accessories
∙
Parallel guide with M6 adapter
$
Waste container for offcuts
£
Work-area light (LED)
|
Cutting blade
¡
Hex key (4 mm)
Q
Installation slot for accessories
W
2362890
*2362890*