(3) You can perform normal forward or re-
verse operation
EMU48720
Single lever switch operation
TIP:
When the single lever switch is activated,
the starboard control lever is inoperable.
You must start all the engines to enable the
single lever switch.
To set
(1) Place the control lever in " " (neutral).
(2) When the "SINGLE LEVER" switch is
pressed, a beep will sound and the LED
will come on.
1. "SINGLE LEVER" switch
2. LED
(3) The port side control lever will allow you
to perform shift and throttle operations
for all outboard motors that have been
started.
1
2
1. Port side control lever
2. Port side engine
3. Starboard side engine
To release
(1) Place the control lever in " " (neutral).
(2) When the "SINGLE LEVER" switch is
(3) You can perform normal shift or throttle
EMU31743
EWM01511
Do not use the reverse function to slow
down or stop the boat as it could cause
you to lose control, be ejected, or im-
pact the steering wheel or other parts of
the boat. This could increase the risk of
2
serious injury. It could also damage the
1
shift mechanism.
Do not shift into reverse while traveling
at planing speeds. Loss of control, boat
swamping, or damage to the boat could
occur.
The boat is not equipped with a separate
braking system. Water resistance stops it af-
ter the throttle lever is moved back to idle.
The stopping distance varies depending on
gross weight, water surface conditions, and
wind direction.
EMU27823
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU48970
Procedure for stopping engine (EKS)
Stopping the engine
3
(1) Press the "START/STOP" switch to stop
pressed, a beep will sound and the LED
will go off.
operations.
Stopping boat
Stopping engine
the engine.
Operation
59