Config Snmp Command; Config Snmp Service Command; Config Snmp Access Command - impinj RShell Reference Manual

Timeout <timeout>
4.2.6

Config SNMP Command

The menu allows the user to configure the SNMP settings for the reader. The config
config snmp
snmp command parameters are shown in Table 4-19.
Command
service
access
write
epcg

4.2.6.1 Config SNMP Service Command

Table 4-20 shows the
Table 4-20 Config SNMP Service Command Parameters
Command Argument
service [enable | disable]
Example to enable the service:
> config snmp enable
Status='0,Success'

4.2.6.2 Config SNMP Access Command

The
config snmp access
settings for the reader. The config snmp access command parameters are shown Table 4-21.
Revision 4.2, Copyright © 2009, Impinj, Inc.
integer Configure the timeout (in seconds) for LLRP reader-
initiated connections before declaring failure. If the TCP
handshake has not completed within this timeout period,
the next server will be tried, subject to the geometric
back-off. For example, for a high-latency WAN, one could
tune this variable higher so that the reader waits longer
for the handshake to complete before giving up on the
connection attempt. A failed connection will invoke the
retry timer (see retry command entry).
Table 4-19 Config SNMP Command Parameters
Enable/Disable the SNMP service.
Sub-menu of access specific commands.
Sub-menu of write specific commands.
Sub-menu of EPCglobal RM MIB specific commands.
parameters.
config snmp service
Format
enum Globally enable/disable the SNMP service. When the
service is enabled, it will be started and when it is disabled
it will be stopped. If the service is enabled when the system
boots, the SNMP service will be started.
command allows the user to configure the SNMP read and write access
Proprietary and Confidential
RShell Reference Manual
Description
Description
21