RShell Reference Manual
4.2.4.8 Config Network NTP Command
The
config network ntp
servers are in addition to any provisioned through DHCP. The command parameters are shown
in Table 4-14.
Table 4-14 Config Network NTP Command Parameters
Command
Argument
add
<ntp server>
del
<ntp server>
delall
An example of the command is:
> config network ntp add myntpserver.com
Status='0,Success'
4.2.5
Config RFID Command
The
menu allows the user to set parameters of the reader's RFID control interface; the
config rfid
parameters are shown in Table 4-15.
Command
llrp
resetstats
4.2.5.1 Config RFID ResetStats Command
The
config rfid resetstats
An example command and response is shown below:
> config rfid resetstats
Status='0,Success'
4.2.5.2 Config RFID LLRP Command
The
command allows the user to configure the LLRP implementation. The
config rfid llrp
parameters are shown in Table 4-16.
18
.
command allows the user to statically configure NTP servers. These
Format
<address>
Add a static server (identified by either an IP address or
hostname) to the list of current NTP servers.
<address>
Delete a statically configured server (identified by either
an IP address or hostname) from the list of current NTP
servers.
Delete all the statically configured NTP servers from the
current list.
Table 4-15 Config RFID Command Parameters
Sub-menu of LLRP-specific configuration commands.
Reset the current RFID statistics.
command resets the RFID statistics maintained by the reader.
Proprietary and Confidential
Description
Description
Revision 4.2, Copyright © 2009, Impinj, Inc.