Config Rfid Llrp Inbound Commands; Config Rfid Llrp Outbound Commands - impinj RShell Reference Manual

Table 4-16 Config RFID LLRP Command Parameters
Command
connclose Initiate a manual close of the current LLRP connection. If no connection exists,
a status code of '8-Permission-Denied' will be returned.
factory Resets the LLRP configuration to its factory defaults. Deletes all configured
RO Specs and Access Specs and restores the factory default LLRP
configuration. This action resets only in-band configuration, not configuration
items controlled by RShell. Note that this command will be rejected with a
status code of '8-Permission-Denied' if a LLRP client connection exists.
resetstats Reset the current LLRP specific statistics maintained by the reader.

4.2.5.2.1 Config RFID LLRP Inbound Commands

The
config rfid llrp inbound
configuration commands. At the moment, only the
own series of subcommands, as described in Table 4-17.
Table 4-17 Config RFID LLRP Inbound TCP Command Parameters
Command Argument
port <port number>
service (on | off)
Usage: config rfid llrp inbound tcp port <port number>
Usage: config rfid llrp inbound tcp service <on|off>

4.2.5.2.2 Config RFID LLRP Outbound Commands

The
config rfid llrp outbound
configuration commands, as shown in Table 4-18.
Revision 4.2, Copyright © 2009, Impinj, Inc.
Description
command provides a submenu of client-initiated connection
Format
integer Configure the port on which TCP connections are
accepted. Default is IANA-assigned port of 5084.
enum Turn on or off LLRP client-initiated TCP connections to
the reader. Disabling this service will cause all future
connection attempts to be refused. Enabling this service
will cause the reader to accept new connections at the
port configured using the port subcommand. Current
LLRP connections are unaffected by this command.
command leads to a submenu of reader-initiated connection
Proprietary and Confidential
RShell Reference Manual
subcommand is supported, which has its
tcp
Description
19