Operation Via The Remote - SHOWTEC Cameleon Bar 50 Manual

Operation via the remote (72704) not included
The remote is necessary for the Cameleon Bar to function.
BLACKOUT button (1): Set the LED power ON or power OFF with this button.
FL button (7): Press this button to activate the Flash function.
Use the + (13) and - (14) buttons to change the flash frequency. + = faster, - = slower
Auto Run Mode
AR button (5): Auto Run Mode
Built-in Program Mode
S PR button (6): Press this button to activate the Built-in program Mode. You have 9 different modes.
Use the + (13) and - (14) buttons to select 7 color modes (R, G, B, R+B, R+G, G+B, RGB),
color jump or color dream.
SP button (8): Press this button to activate the Running Speed function. This function is only available in
color jump or color dream Mode. Use the + (13) and - (14) buttons to change the running
speed. + = faster, - = slower
Sound-active Mode
SA button (10): unavailable for outdoor LED lights.
Slave Mode
SL button (11): Slave mode
DMX Mode
D button (9): DMX Mode
S button (12): Press this button to start the DMX Address setup.
Use the buttons to set the address
For example, if you want to set DMX address 184.
1) Press the S button, the Red LEDs will be on, meaning you can set the DMX address.
2) Press the 1 button, the Green LEDs will be on, meaning the 1 (hundreds) setting was successful.
3) Press the 8 button, the Blue LEDs will be on, meaning the 8 (tens) setting was successful.
4) Press the 4 button, then all the RGB LEDs are on, meaning the 4 (value 0-9) was successful.
All LEDs will flash twice.
After your DMX address setting, you have to press the DMX button (9) to control the device via DMX.
Manual Mode
Manual color setting
R (2), G (3), B (4): Press one of these buttons to activate manual color setting. Use the + (13) and - (14)
buttons to change the brightness of the RGB LEDs. (brightness has 26 different grades)
Press the +/- buttons, do not hold down the buttons because this won't function
12
1 2 3 4
5 6 7 8
9 10 11 12
13
14