Table of Contents
Advertisement
DMX Channel Setting
Channel 1 – Dimmer
0-255
Channel 2 – Red
0-255
Channel 3 – Green
0-255
Channel 4 – Blue
0-255
Channel 5 – Flash Speed
0-255
Maintenance
The Showtec Cameleon Bar requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture's light-output will be significantly reduced.
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric power, and
then wipe the connections with a damp cloth. Make sure connections are thoroughly dry before linking
equipment or supplying electric power.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
1. If the device does not operate properly, unplug the device.
2. Check the power from the wall, all cables etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If you are unable to determine the cause of the problem, do not open the Cameleon Bar, as this
may damage the unit and the warranty will become void.
5. Return the device to your Showtec dealer.
Dimmer from 0 – 100%
Red from 0 – 100%
Green from 0 – 100%
Blue from 0 – 100%
Flash speed from slow to fast
Disconnect the mains power supply, and
13
Advertisement
Table of Contents
