Table of Contents
Advertisement
Installation
Remove all packing materials from the Cameleon Bar. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
When the mounting bracket (1) isn't fitted, you will first have to fit the mounting bracket in order to hang
it from a ceiling. You can also place this device on the floor.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
Control Modes
There are 5 modes:
One Cameleon Bar
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Cameleon Bar is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the Auto run programs.
One Cameleon Bar
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Cameleon Bar is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the Auto run programs.
One Cameleon Bar (NO Sound-control)
Although the remote control says Sound-control, it won't function with this device, because this is an
outdoor device.
• Auto run (Page 8+12)
• Built-in programs (Page 8+12)
• Master/Slave (Page 9+12)
• DMX512 (Page 9+12)
• Manual Control (Page 12)
(Auto run
programs)
(Built-in
programs)
8
Advertisement
Table of Contents
