Warnings - ICT DISTRIBUTION 2 Series Instruction Manual

WARNING
Risk of serious personal injury or damage to equipment and property! Always observe the
following:
Use an appropriately rated over-current protection device in line with the main battery connection
to the Distribution Panel input to protect the high current input wiring
Use an appropriately rated disconnect switch or circuit breaker in line with the Distribution Panel
input to enable installation and service with the battery or power source disconnected
Always disconnect main power source before installing or removing fuses, or connecting or
disconnecting wiring
Use wire and connectors rated for the maximum load current and size of fuse or circuit breaker
Carefully observe wiring polarity when making input and output connections
Securely tighten all connections and insert fuses fully
No internal user serviceable parts. Refer all product service to an authorized ICT Ltd. service
facility
CAUTION
Risk of personal injury or damage to equipment! Always observe the following:
Fuses may be HOT to touch. Disconnect power and allow to cool before removing or replacing
Wiring terminals may be HOT to touch. Disconnect power and allow to cool before disconnecting
load wires
Install in a protected environment, keep sources of moisture away from unit
NOTE
Due to the breaker/fuse detection circuitry internal to the distribution panel, it may be possible to
measure a voltage on the output terminal(s) even if that output's breaker or fuse is open (with no
load connected). This is normal operation. The detection circuitry is a high-impedance circuit,
and while a voltage may be present on the output terminal, it is purely a signal voltage and does
not support loading. Any load device connected to the output will immediately pull this voltage
to zero volts.
2