E-Mail Setup - ICT DISTRIBUTION 2 Series Instruction Manual

E-MAIL SETUP

Configure these settings if you would like to receive e-mail alarm notifications from the panel. The
information for the following settings is available from your Network Administrator or Internet Service
Provider (ISP).
E-MAIL
SMTP Server: The name or IP address of your SMTP server used for sending outgoing e-mail.
SMTP Server requires SSL: Check this box if your SMTP Server requires an encrypted SSL connection.
SMTP Port: The port used by your SMTP server. The standard port used by most SMTP servers is 25.
Sender E-mail Address: Enter the e-mail address you wish to appear as the sender of the e-mail
notifications.
Recipient E-mail Addresses: Enter the e-mail addresses you wish to receive the e-mail notifications.
If multiple e-mail addresses are entered, use commas to separate the addresses. This field can also be
used to send a text message notification to a cell phone. See the Text Message Alarm Notifications
section for more information.
SMTP User Name: If your SMTP server requires a user name and password, enter the user name here.
Leave this field blank if your SMTP server does not require authentication.
SMTP Password: If your SMTP server requires a user name and password, enter the password here.
Leave this field blank if your SMTP server does not require authentication.
Minimum E-mail Interval: This setting allows you to specify how many minutes have to elapse
between e-mail notifications. This setting is used to prevent your network from being flooded with
alarm e-mails if your alarm thresholds are not set correctly. The default setting is 1 minute. This setting
can be changed to anything between 0 and 60 minutes.
GENERAL E-MAIL NOTIFICATIONS
The Distribution Panel restarts: Check this box to receive an e-mail notification when the panel
restarts after a power failure or a soft reset.
15