NOMA MILTON 052-9717-8 User Manual page 22

•
After following all the steps, if the wobbling problem is not solved, a
dynamic balancing needs to be done with balancing kit. Follow the
procedure listed:
• Turn the fan off. Select one blade and place the plastic clip on it, so
that the plastic clip is located halfway between the blade holder
and the blade tip on the edge of the blade.
• CAUTION: The plastic clip should be placed on the windward edge
of the blade to avoid clips flying off.
• Turn the fan on (use the speed that causes the most wobble).
Observe if the wobble is better or worse. Turn the fan off and move
the clip to the next blade. Do the same for all blades and note on
which blade the clip reduces the wobble most. Place the clip on the
blade which showed the most improvement. Move the clip inward
and outward on this blade and operate the fan to find the position
where the clip gives the most improvement.
CAUTION: Stay clear of the blades. If the clip, for any reason, is not
•
secure, injury could result.
• Once the exact position is determined, place a weight on the top of
the blade, on its centre line and closest to the clip. Peel the paper
off the back of the weight and press firmly to ensure that it is
securely attached to the blade. Remove the clip.
• CAUTION: Clean the surface of fan blade before placing the
balancing weight so that the balancing weight can be firmly
attached on it.
Specification
Assembled dimensions (W x D x H)
Ceiling to blade height
Full lamp height after installation
Weight
52 x 52 x 11" (132 x 132 x 28 cm)
7 1/8" (18 cm)
11" (28 cm)
14 lb 8 oz (6.6 kg)
22