Points For The Boiler User; Troubleshooting - IDEAL LOGIC SYSTEM s15 User Manual

Table of Contents

POINTS FOR THE BOILER USER

Note. In line with our current warranty policy we would ask that you check through the following guide to identify any

problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other

than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is

not gained by the engineer.

TROUBLESHOOTING

NO CENTRAL HEATING

Check the mains power is turned on

and ensure mode control knob (B) is

in the ON position

Check the programmer (external to

the boiler) is in an "ON" position and

the room thermostat is turned up

Does the boiler operate and provide

central heating?

Check the time settings on the

programmer are as you require and

adjust if necessary

See boiler "Operation Modes" and

"Fault Codes" section. If "0 0" is

displayed then contact a Gas Safe

Registered Engineer or in IE a

Registered Gas Installer (RGII)

FOR ANY QUERIES PLEASE RING THE

IDEAL CONSUMER HELPLINE : 01482 498660

NOTE. BOILER RESTART PROCEDURE -

To restart boiler, press the "RESTART" button.

User's

YES

NO HOT WATER

Check the mains power is turned on

and ensure mode control knob (B) is in

the ON position

Check the programmer (external to the

boiler) is in an "ON" position and the hot

water cylinder thermostat is turned up