Stand-Alone Mode; Dmx Mode - EuroLite LED D-1000 User Manual

Stand-alone Mode

In the Stand Alone mode, the device can be used without a controller. The device features a memory
function. The last program confirmed via the ENTER button will begin anew when the device is restarted.
Auto Mode
In Auto Mode the internal programs are called up automatically in a continuous loop.
Press the MODE button until the LED display shows A 1.
You can now choose the desired program (A1 – A9).
Via the UP or DOWN buttons you can choose the desired program speed (1 – 9).
Please press the ENTER button to confirm.
Sound Control Mode
Press the MODE button until the display shows S 1.
You can now choose the desired program (S1 – S3).
Via the UP or DOWN buttons you can choose the desired program speed (1 – 9).
Please press the ENTER button to confirm.
You can adjust the sensitivity with the rotary-control on the rearpanel.
L-Mode
Press the MODE button until the LED display shows L 1. In this mode the LEDs stay lit, even if no music is
played.
At L 0 the LEDs extinguish when no music is played.
Choose the desired mode and confirm with the ENTER button.
Then choose the desired sound control program and also confirm with the ENTER button.
Master/Slave Setting
Set the Master device to the desired program in Auto or Sound Mode and press the ENTER button to
confirm.
Set each Slave device to the same DMX address d00 1 and again press the ENTER button to confirm.

DMX Mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows the DMX mode d001.
Set the desired address via the UP or DOWN buttons (d001 - d512).
Please press the ENTER button again to confirm.
Attention:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
21/23 00086340, Version 1.0