Power Conservation; Part Counting; Set Part Counting - Husky Altanium Delta5 User Manual

To enable the cabinet internal temperature alarm, do the steps that follow:
1.
2.
3.

10.5 Power Conservation

To conserve power, the Altanium controller lets you set the display to automatically turn off
(change to a dark screen) if it is not used in a set interval of time. When it turns off, touch the
screen to turn it on again.
To enable the power conservation feature and set the timer, do the steps that follow:
1.
2.
3.
4.

10.6 Part Counting

Optional digital inputs and an output are available to automatically count parts. The system
also lets you set a sack full limit, so users do not have to manually calculate when the sack is
full.

10.6.1 Set Part Counting

To set Part Counting, do the steps that follow:
1.
2.
3.
120
Touch the Servo Cabinet Internal Temperature button below Equipment Protection.
NOTE: The current internal cabinet temperature and the maximum temperature are
shown in their related fields.
Touch the Enable Alarm check box.
Touch the Exit button.
On the System Setup screen, touch the Main tab.
Touch the Turn Off Display After field.
Type the number of minutes from 1 to 300 and touch the Accept button.
Touch the Turn Off Display check box, so the check mark shows.
The power conservation feature is now enabled.
On the System Setup screen, touch the Heats Setup tab and then the Control Page 2
tab.
Touch the Setup button below Part Counting.
The Part Counting - Setup dialog window shows. Refer to
Touch the Assign Heater Types button if this was not done before. This will show the
Quick Set screen. For more information refer to
NOTE:
The Heater Type parameter must be set to Tips for all zones of a cavity in the
mold. If no zones have a Heater Type parameter assigned, an error message will
show.
v 1.0 — February 2020
Figure 10-7.
Section 7.6.
Altanium Delta5
Power Conservation