Energy Usage And Units; Number Of Zones In The System - Husky Altanium Delta5 User Manual

User Guide

10.15 Energy Usage and Units

Energy accumulation data is updated every three seconds and shown in real time to the user
on the Energy Display screen. Users can set the Energy Cost Rate (Kwh) and Currency Type.
To change the energy usage and units, do the steps that follow:
1.
2.
3.
4.
5.
Figure 10-12 Energy Display Screen

10.16 Number of Zones in the System

It could be necessary to add or remove zones to an current mold setup. If the mold that is
running has less control zones than those listed on the Altanium controller screen, users can
remove the unused zones so they are not shown.
To change the number of zones in the system, do the steps that follow:
1.
2.
3.
Energy Usage and Units
Touch the Energy Display button on the Home screen.
The Energy Display screen shows. Refer to
Touch the Energy Cost Rate (Kwh) field below Energy Usage and Units.
Enter the kWh cost rate and touch the Accept button.
Touch the Currency Type button field below Energy Usage and Units.
Touch the currency type from the list.
From the Home screen, touch the Zone Slot button.
Touch the zones that will be enabled or disabled.
Touch the Slot Enable field.
v 1.0 — February 2020
Figure 10-12.
System Setup Screen
129