Table of Contents
Advertisement
2.3Explanationof symbols
This section gives an explanation of all the symbols shown on the type label.
Symbols on the Type Label
DANGER!
3. Introduction
3.1 Basic features
The I1000-RH1 series hybrid inverters apply to PV energy storage system with PV modules, battery,
loads and grid. The energy produced by PV system shall be used to optimize self-consumption,
excess power charge battery and the rest power could be fed into the grid. Battery shall be
discharged to support loads when PV power is insufficient to meet self-consumption. If both PV
power and battery power is insufficient, the system will take power from grid to support loads.
CE mark. The inverter complies with the requirements of the
applicable CE guidelines.
Beware of hot surface.
The inverter can become hot during operation.
Avoid contact during operation.
Danger of high voltages.
Danger to life due to high voltages in the inverter!
Danger.
Risk of electric shock!
The inverter cannot be disposed of together with the
household waste.
Disposal information can be found in the enclosed
documentation.
Don't work on this inverter until it is isolated from battery,
mains and on-site PV generation suppliers.
Danger to life due to high voltage.
There is residual voltage in the inverter which needs 5 min to
discharge.
Wait 5 min before you open the upper lid or the DC lid.
Please read this manual before installation.
RCM (Regulatory Compliance Mark)
The product meets the requirements of the applicable Australian standards.
PV Panels
Hybrid Inverter
Battery
EPS Load
Figure 3-1 PV Energy Storage System
DANGER!
TUV mark.
Monitor
Meter
Grid
Normal Load
5
Advertisement
Table of Contents
