Table of Contents
Advertisement
12
Open the package and pick the product, check that if there is any distortion or impaired during
the transportation. Meanwhile, check that if the relating accessories and the materials are here,
you can see the accessories list in the table.
The instruction manual is an integral part of the unit and should therefore be read and kept
carefully.
It is recommended that the packaging should not be removed until the unit is located in the
installation site.
5.2 Check for transport damage
Check if the I1000-RH1 series inverter has some visible external damage, such as cracks in the
housing or display please contact with your dealer if you find any damage.
5.3 Installation precaution
The I1000-RH1 series inverter is designed for outdoor installation (IP65)
Make sure the installation site does not fall into one of the following conditions:
·Do not install the inverter in direct sunlight.
·Do not install the inverter on flammable construction material.
·Do not install the inverter in areas where highly flammable materials are stored.
·Do not install the inverter in potentially explosive areas.
·Do not install the inverter during periods of precipitation or high humidity (>95%); Moisture
trapped within the location may cause corrosion and damage to the electric components.
·Provide adequate ventilation when using batteries, and also read the warning label on the
bottom of the inverter.
·Install the inverter in a location that maintains an ambient air temperature that is less than
40°C;That is to maintain a safe internal component temperature; the inverter would reduce
power if the ambient air temperature exceeds 40°C.
·The inverter should be installed in a location that is not accessible for children.
·The inverter emits a slight vibrating noise when operating, which is normal and no effect on
performance.
·The slope of the wall should be within ±5°.
·The inverter is heavy, ensure the mounting place is strong enough to hold the weight of the
inverter.
·If you install the inverter in a cabinet, closet or other small enclosed area, sufficient air
circulation must be provided in order to dissipate the heat generated by the unit.
5.4 Available space
300mm
500mm
300mm
500mm
Figure 5-1 inverter space size
600mm
Advertisement
Table of Contents
