Installation Steps - Energy I1000-RH1 Series User Manual

14
·Transportation must be carried by specialized person (truck operators. Hook-up personal),
equipped with the necessary protection equipment (overalls, safe shoes, protective gloves,
helmets, goggles)
·Do not walk or stand beneath or in the proximity of the load.
·Avoid sudden movements and jolts when unloading and positioning the unit. Internal handling
procedures must be conducted with care. Do not exert leverage on the components of the machine.
·If the unit is not balanced apply ballast. Any protruding parts should not be supported by hand.
·The inverter should be installed so that the operating panel shall be easily accessible- easy access
to the electrical power connection point.
·Accessible for maintenance and repair work.
·Parts serving for support or immobilization of unit shall be designed and manufactured so as
to minimize the risk of physical injuries and accidental loosening of fixings.
·Loading capacity and hardness of the supporting surface, load rating of mounting bracket
should be at least four times the weight of the devices according to IEC62109-1. And supporting
characteristics will be impaired by wear, corrosion, material fatigue or ageing, This should be calculated
by inspection of the design data of supporting material and consulting construction engineer.

5.6 Installation steps

Step 1: Screw the wall bracket on the wall
·Use the wall bracket as a template to mark the position of the 4 holes.
·Drill holes with ф10 driller carefully, make sure the holes are deep enough (at least 45mm) for
install and tight the expansion tubes.
·Install the expansion tubes in the holes, and tight them. Install the wall bracket using the
expansion screws in the screw package.
Step2: Hang the I1000-RH1 series inverter on the wall bracket.
·Transportation of the inverter needs at least 2 people, each one needs to use the handles at
the sides of the inverter.
·Hang the inverter over the bracket, move the inverter close to it, slightly laydown the inverter
make sure the 4 mounting bars on the back of the inverter is fixed well with 4 grooves on the bracket.
320mm
110mm