Terminals - Energy I1000-RH1 Series User Manual

8
Work mode: Back up mode
Priority: battery>load>grid
2
This mode applies the area that has electricity price between peak and valley. User can use
off-peak electricity to charge the battery. The charging and discharging time can be set
flexibly, and it also allows choosing whether charge from the grid or not.

3.3 Terminals

The I1000-RH1 series hybrid inverters apply to PV energy storage system with PV module, battery,
loads and grid. The energy produced by PV system shall be used to optimize self-consumption,
excesspowercharge battery and the rest power could be fed into the grid. Battery shall be
discharged to support loads when PV power is insu cient tomeet self-consumption. If both PV
power and battery poweris insu cient,the system willtake powerfrom grid to supportloads.
1
4
3
1
Generated solar energy
2
Storage in Battery
3
Load consumption
4
Grid supply power
WARNING!
Make sure the load powering rating in within the EPS's output rating. Or the
inverter will shut down with an 'over load' warning.
When an 'over load' is appeared, adjust the load power make sure it is with
the range of the EPS output, and turn the inverter on.
For the nonlinear load, please pay attention to the inrush power make sure
it is within the range of the EPS output.
B C D E
A
Figure 3-2 Terminals
F G H