Troubleshooting - Energy I1000-RH1 Series User Manual

34
6.4.1.Reactive Power
(For specific country if required by the local grid.)
There are 5 modes for selecting: None, Fixed PF, Fixed Q,
CosphiP, and Q(U), end user can select the corresponding
mode according to local standards.
Fixed PF
Fixed Q
CosphiPLockinV CosphiPP2
CosphiPLockOutV CosphiPPF3
CosphiP
CosphiPPF1 CosphiPP3
CosphiPP1 CosphiPPF4
CosphiPPF2 CosphiPP4
Q(U) enter delay QuQ2
Q(U) LockinP QuV3
Q(U) LockoutP QuQ3
Q(U)
QuV1 QuV4
QuQ1 QuQ4
QuV2
6.4.3. DRM function
DRM function is Demand Response Mode which is required
by standard NZS4777.2.and applies to NZS4777.2 only. The
default value is "enable" Choose "disable" means the
funciton is turn off.

7 Troubleshooting

7.1 Troubleshooting
This section contains information and procedures for solving possible problems with the I1000-RH1
series inverters, and provides you with trouble shooting tips to identify and solve most problems that
could occur with the I1000-RH1 series inverters. This section will help you narrow down the source of
any problems you may encounter. Please read the following trouble-shooting steps.
Reactive
Basic
system switch Meter Address
RTC Modbus Address
Language DRM0 state
DRM0
Grid Code Meter En/Dis
pv config Remote power
Password control
6.4.2. P(U) function
P(U) function is Volt-watt response mode which is required
by standard NZS4777.2 and applies to NZS4777.2 only.
The default value of the function is "enable", choose "disable"
means the funciton is turn off.
6.4.4. Power rate limit function
Power rate limit function is required by standard NZS4777.2
and applies to NZS4777. 2 only. This function is defined as a
percentage of rated power per minute.
Safety
P(U)
P(U)
P(u) Enable P1
V1 P4
V2 P(U)delay
V3 power decline gradient
V4