Toro 60216C Operator's Manual page 40

1. Oil-level-check 3. Oil-level port
bolt
2. Washer 4. Pulley
7. Remove the oil-level-check bolt and washer
from the oil-level port in the side of the reduction
case (Figure 60).
8. Align a drain pan to the hinge of the engine deck
(Figure 61).
9. Rotate the engine on the hinge side of the
engine deck, and drain the oil from the reduction
case (Figure 61).
10. Carefully lower the engine and engine deck.
11. Slowly pour the specified oil into the fill port
until the oil level is level with the threads at the
bottom of the oil-level port
12. Install the oil-level-check bolt and washer to the
oil-level port of the reduction case, and tighten
the bolt (Figure 60).
Figure 60
5. Filler port
6. Filler bolt
Figure 61
(Figure 59).
13. Install the filler bolt and washer to the filler port
of the reduction case and tighten the filler bolt
(Figure 60).
14. Install the engine; refer to
(page 35).
g020127
g020128
40
Installing the Engine