Table of Contents
Advertisement
Figure 30
1. O
position
FF
6.
Add the ingredients for the batch as follows:
A.
Pour water into the drum through the grate.
B.
Add the plaster, cement, or other binding
material.
Note:
You can open bags of cement,
plaster, and binding materials by lowering
the bag onto the bag splitter
Figure 31
C.
If you are using sand and/or other
reinforcing materials, add them into the
drum.
g019873
2. O
position
N
(Figure
31).
g021179
7.
Allow the paddles to mix the material until the
ingredients have a uniform appearance.
Note:
If needed, add water or plaster, cement,
or other binding material until the consistency
of the batch is correct.
Dumping the Material
DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum while
the engine is running.
Note:
When dumping a batch of material, leave
the engine/motor running and the clutch in the O
position so that the rotating paddles help discharge
the material.
1.
Align a wheelbarrow or similar container of
adequate capacity in the path of the drum
opening.
2.
Grasp the dump handle with your left hand
(Figure
32).
1. Dump handle—Mix
position
2. Drum latch—Release
position
3.
Lift the handle of the drum latch
24
Figure 32
3. Drum latch—Locked
position
4. Dump handle—Dump
position
(Figure
N
g028574
32).
Advertisement
Table of Contents
