Table of Contents
Advertisement
Connecting the Safety Chains to
the Tow Vehicle
1.
Pull the safety chain through the slots in the
keyholes, so that the lengths on each side are
equal.
2.
Cross both lengths of chain under the tow pole.
Note:
Crossing the chains decreases the
chances of the front of the machine dropping
to the ground if the hitch does not hold the
connection.
Figure 18
1. Connecting links
2. Keyholes in front post
3.
Connect each length of chain to the safety
chain mounting point on the tow vehicle with the
connecting links
Important:
Ensure that the chain has
enough slack for turning around corners
when towing the machine.
Note:
Stow the excess chain inside the bottom
of the front post by pushing it into the keyholes
and latching the appropriate links into the
keyhole slots.
3. Chain crossed under tow
pole
(Figure
19).
1. Connecting link
2. Safety chain mounting
point on tow vehicle
Connecting and Checking the
Lights
Machines Equipped with a Light Kit Only
1.
Connect the electrical plug of the machine with
g021177
the electrical plug of the tow vehicle
Note:
The machine uses a standard 4-pin, flat
plug. If your tow vehicle has a different type
of plug, obtain an adapter from an automotive
parts store.
2.
Ensure that the tow vehicle is in the N
position, engage the parking brake, and start
the engine.
3.
Test the lights as follows:
A.
Turn on the headlights of the tow vehicle.
The tail lights of the machine should
illuminate.
B.
Press the brake pedal of the tow vehicle.
The brake lights of the machine should
illuminate.
C.
Operate each turn signal of the tow vehicle
in turn.
18
Figure 19
3. Chain link
4. Chain
(Figure
Figure 20
EUTRAL
g019927
22).
g020828
Advertisement
Table of Contents
