Table of Contents
Advertisement
5019_719_01120_GB_STEP_FILO:Layout 1
Induction zone functions
The time remaining can also be changed by
pressing the clock symbol button (4) at any time
and using the +/- buttons (3) to alter the time. The
light above the display will flash for 10 seconds,
then the display will show the amended time
remaining. When the programmed time expires a
continuous double signal will be heard. If a zone
has been programmed using the timer option when
the time expires the zone and the zone indicator
will automatically switch off. You do not have to
select a power level when using the timer option.
the timer is activated by pressing the clock button
(4). The timer option can be set on the induction
zone that is not being used.
The Lo option: heat maintenance is an option
that allows you to keep cooked food hot. Turn it
on using the button (3) by lowering the selection
below level 1 on either of the rings. It can be set
at maximum for 120 mins.
The P option or fast boil: an option that sets a
level of power greater than the maximum level
(10) in order to bring water to the boil very
quickly. Select it by pressing the + button (3),
increasing the power level above 10.
This option can be used on both induction
zones, but can only be used twice per zone in
any 60 minute period.
Positioning the pan supports and Wok support
Position the pan supports by inserting them
in the slot inside the gas ring. To use the
wok support provided, position it as shown
in the diagram.
19-07-2007
14:04
Pagina 7
Warning: for safety reasons, the fast boiling
function will remain active for 5 minutes.
After this time the control system will
automatically reduce the power level to the
10 value.
Warning, when using the Fast Boil option (P) and
high levels of power, especially if both zones are
being used simultaneously, the appliance may
become noisy.
Indication of residual heat. After turning the
ring off, an "H" will be displayed until the
temperature of the hob falls to an acceptable
temperature, usually below 65°C.
IMPORTANT: the hob's safety equipment
includes an automatic shut off function. Prolonged
use of the same power setting will switch off the
induction zone (for example after about 1 hour at
maximum power level, the zone will turn off).
IMPORTANT: do not use pots or pans with a
diameter greater than 14 cm on the induction
rings.
When cooking using high quantities of water, use of
the gas burners is recommended.
Please read all the instructions carefully and
keep them in a safe place.
7
Advertisement
Table of Contents
