Related Manuals for KitchenAid KHMF 9010/I
Summary of Contents for KitchenAid KHMF 9010/I
- Page 1 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 1 KHMF 9010/I Instructions for use...
- Page 2 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 2...
-
Page 3: Table Of Contents
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 3 Product description and symbols Gas burner functions Practical advice on how to use the burners Injectors table Induction zone functions Positioning the pan supports and Wok support Sizes and installation measurements (mm) Precautions and general recommendations Safeguarding the environment Installation Gas connection... -
Page 4: Product Description And Symbols
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 4 Product description and symbols 1. Removable pan supports 2. Professional double crown Wok burners 3. 145 mm diameter induction zone 4. Left gas burner control knob 5. Central gas burner control knob 6. Right gas burner control knob 7. -
Page 5: Practical Advice On How To Use The Burners
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 5 Practical advice on how to use the burners Read these instructions to get the best out of your - The use of two burners simultaneously with just burners: one container such as a fish kettle. - Use pans with a diameter the same as the burner (see pan diameter table to the side). -
Page 6: Induction Zone Functions
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:03 Pagina 6 Induction zone functions This hob is fitted with 2 induction zones that allow you to boil water very quickly, as well as control the temperature with extreme precision, giving you The child safety option can be turned on by a vast range of cooking options. -
Page 7: Positioning The Pan Supports And Wok Support
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 7 Induction zone functions The time remaining can also be changed by Warning: for safety reasons, the fast boiling pressing the clock symbol button (4) at any time function will remain active for 5 minutes. and using the +/- buttons (3) to alter the time. -
Page 8: Sizes And Installation Measurements (Mm)
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 8 Sizes and installation measurements (mm) NOTE: If a hood is installed above the hob, read Rear wall the instructions for fitting the hood where it indicates the correct distances to be complied Front with. •... -
Page 9: Precautions And General Recommendations
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 9 Precautions and general recommendations To get the best out of your hob, please read the • The appliances should only be repaired or instructions carefully and keep them for future adjusted by a qualified electrician. consultation. -
Page 10: Safeguarding The Environment
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 10 Safeguarding the environment Packing • this hob can come into contact with food and The packaging material is 100% recyclable and is complies with EEC (CE) Regulation n. labelled with the recycling symbol that 1935/2004. -
Page 11: Installation
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 11 Installation Technical information for the installer • This product can be built into a 20 to 40 mm deep worktop. • The hob cannot be installed with an oven underneath. Always insert a separator panel under the hob at a distance of no less than 25 mm from the lowest point (electronic control module) on the appliance. -
Page 12: Gas Connection
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 12 Gas connection The gas mains system must comply with local regulations. • The paragraph on “national legislation reference” shows the local legislation specific to the country of destination. • Should there be no information regarding your country of interest, ask for further details from the installer. -
Page 13: Securing The Hob Into Cabinetry
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 13 Securing the hob into cabinetry 1. After cleaning the surfaces around the edges, fit the seal provided around the hob. 2. Position the hob inside the opening according to the sizes indicated in the description sheet. 3. -
Page 14: Replacing The Injectors
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 14 Replacing the injectors (See the product description sheet for model) Remove the bottom of the hob, lifting out the installation brackets to change the dual crown wok burner injector. Please contact the Customer Care Centre. REMOVING THE MAIN INJECTOR Remove the injector (F) using a 10mm spanner. -
Page 15: General Cleaning
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 15 General cleaning In order to keep your hob in good condition, you Note: in the models fitted with electronic ignition must keep it clean, removing any food residue each and safety thermocouples, you have to clean the time you use it. -
Page 16: Troubleshooting Guide
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 16 Troubleshooting guide The hob is not working properly or not working at 2. If one of the following codes appears when you all. Before calling the Customer Care Centre, see if press the ignition button on the hob: ER31, the problem you are encountering is mentioned in ER47, ER36, ER39, ER20, ER37, ER22, E5, E6, this guide. -
Page 17: After Sales Service
5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 17 After Sales Service Before contacting the Customer Care Centre, clarify that you cannot resolve the problem yourself based on the descriptions given in the “Troubleshooting guide”. 1. Turn the apparatus off and restart it to see if the fault is repeated. - Page 18 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 18...
- Page 19 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 19...
- Page 20 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 20 Whirlpool Europe S.r.l. Viale G. Borghi, 27 - 21025 Comerio (VA) Phone 0332.759111 - Fax 0332.759268 www.whirlpool.eu Printed in Italy 07/07 5019 719 01120...